Tying A Custom Hand Tied Gummie Jig

 

All Pepop’s Handtied Crappie Jig’s are tied using the highest quality materials. I also tie a special jig I call the Gammie jig that is currently made in six
styles.

Below are the steps it takes to tie a Gummie Jig.

Step #1
First I pick a painted head
and

wrap a thread base from the head about 1/4″down the shank.


Step 1 in creating a custom handtied jig

Step #2
Then I select the plastic I’ll use (I prefer Crappie Thunder’s because they have bulk & are fairly tough but about any solid body plastic will do) and cut the tail off.

Step 2 in creating a custom hand tied jig

Step #3
Thread the body onto the hook
and

apply a tiny drop of super glue to the thread base and push the plastic against the jighead.

Step 3 in creating a custom handtied jig

Step #4
Clamp hook in vise

and with forceps, push body towards the jighead and clamp it.

Step 4 in creating a custom handtied jig

Step #5
Wrap a thread base to the hook bend

Step 5 in creating a custom handtied jig

Step #6
Tie in flash (I use 1 strand, doubled twice making 4 strands).

Step 6 in creating a custom handtied jig

Step #7
Pull & stack hackle barbules for tail and tie in, tie 2 half-hitches and cut thread.

Step 7 in creating a custom handtied jig

Step #8
Apply a tiny drop of super glue to thread just below clamp.

Step 8 in creating a custom handtied jig

Step
#9
Remove clamp and pinch & twist body to push plastic over
thread/glue. Cut flash to desired length

Step 9 in creating a custom handtied jig

Leave a Reply

Your email address will not be published. Required fields are marked *